Auxiliary Connectors; Manual Transmission Vehicles - Ultra Start 25 series Install Manual

INSTALL MANUAL
PAGE 10
Step 1 - Connect All Of the Following Wires
Main Connector (6pin)
YELLOW
Starter Output - 12volts during start position only.
GREEN
Heater/Acc Output - 12volts in the accessory position off during
RED
12volt 30amp Input - 12volts from ignition harness or battery.
RED
12volt 30amp Input - 12volts from ignition harness or battery.
BLUE
Ignition Output - 12volts in the ignition, start and run positions.
WHITE*
Selectable Output - Selectable Output for vehicles that may
Auxiliary Connector (14pin)
BLACK
WHITE
GRN/WHT
BLUE/WHT
PINK
WHT/BLUE
"M" Series
BLK/WHT
GREEN** or
PURPLE**
Important!
Never install an AUTOMATIC TRANSMISSION module into a
MANUAL TRANSMISSION vehicle!
System Ground Input - Connect to Chassis Ground.
Park Light Output - Connect to Park Light system.
Hood Pin Input - Connect to the Hood Pin Safety Switch.
Tach Input - Connect to A/C Tach source. (Above 2 volts AC)
Brake Switch Input - Connect to (+) when the brake pedal
Siren Output - Connect to positive side of Siren.
(yellow case)
Park Brake Input - Connect to Park Brake wire.
Door pin Input - Connect to (-) wire when door open
Door pin Input - Connect to (+) wire when door open
start and 14volts during run.
require a 2nd Ignition, Accessory or Start.
*(See jumper diagram page 7)
is applied.
**Connect only ONE of the door input wires.
REMOTE VEHICLE STARTER