Table of Contents
Advertisement
WIRING - 6 PIN HARNESS
Red Wires: +12 VDC Main Power Source Input.
Connect these two Red wires to a main constant +12 VDC power
Black: Chassis Ground
Connect this Black wire securely to a clean, solid negative chassi
Blue: Ignition - Switched +12 VDC Output
Connect this Blue wire to the ignition wire supplying + 12 VDC when the
key
is in the ignition "On" and "Start" position.
NOTE: some vehicles have 2 ignition sources - See Ignition 2 on the 14
Connector
Yellow: Starter Output
Connect this Yellow wire to the vehicle's starter wire (12v+ during
NOTE: Most Nissan vehicles have 2 starter wires
Manual transmission vehicles with clutch safety must have starter wire
connected
on the starter side of the cancel switch or a bypass relay installed.
Green: Accessory +12 VDC output - Heater/Air Conditioner
Connect to heater wire on vehicle. ( 12V+ in accessory position) Heater fan
operates when energized.
NOTE: Many vehicles require more than 1 heater wire to be energized to have
proper operation of heater control unit.
NOTE: Some vehicles require a addition wire to be energized for proper operation
of the AC.
WIRING - 14 PIN HARNESS
White: +12 VDC Output for Flashing Parking Lights.
Connect this White wire to positive side of the parking lights wire
Red/White: 2nd Channel Output for trunk Release
This Red/White wire supplies 250 ma negative output when button # 2 is
for 1 ½ seconds.
Note: This can also be used for Driver's Door Unlock priority
Blue/White: + 12 VDC Output for Ignition 2 Wire.
Connect this Blue/White wire to the second Ignition wire. (15 amps Max Current)
Important: If the second ignition requires more than 15 amps or for connection
to a 3rd or 4th ignition, connect this Blue/White wire to Pin 85 of an automotive
relay, Pin 86 to ground, Pin 87 to constant + 12 VDC and Pin 30 to the additional
ignition wire vehicle.
Brown: Negative Output for Horn or Siren.
Horn (Negative Trigger) - Connect the Brown wire to Pin 85 of an automotive
relay, Pin 86 and Pin 87 to ground and Pin 30 to the horn wire.
Horn (Positive Trigger) - Connect the Brown wire to Pin 85 of an automotive
relay, Pin 86 to ground, Pin 87 to fused (+) 12 VDC and Pin 30 to the horn wire.
s
.
ground.
cranking).
.
.
.
ignition
pin
.
Advertisement
Table of Contents
