Ultra Start Pro Series Installation Manual page 12

Remote car starter
Hide thumbs Also See for Pro Series:
Table of Contents

Advertisement

RELAY DIAGRAMS
STARTER KILL 2500 SERIES
ACC
Off
STARTER KILL 1500 SERIES
ACC
Off
REMOTE STARTER - Self Diagnostics
Starter will not Attempt Remote Start
Park Lights
4 Flashes
4 Flashes
4 Flashes
NONE
NONE
7 Flashes
Starter Shutdown - While Running
LED STATUS
3 Flashes
5 Flashes
6 Flashes
7 Flashes
If the remote starter is shut down because of one of the inputs, the system's advanced diagnostics will record the event in
memory and flash the systems LEDs to indicate the fault.
NOTE: :LED status will be cleared when ignition is turned ON. For proper memory clearing, insure that Ignition #1 (BLUE) is
connected to ignition on vehicle
ALARM SYSTEMS - Self Diagnostics
STATUS LED
EVENT IN MEMORY Notes:
OFF
System Disarmed
Single Flashes
System Armed
2 Flashes
Sensor Input
4 Flashes
Ignition Input
5 Flashes
Hood Input
6 Flashes
Brake Pedal
ON STEADY
IN VALET MODE
If the alarm system was triggered while armed the system will retain a memory of this event for advanced diagnostics.
When disarming the alarm, the siren/horn will chirp 3 times instead of the usual 2 times to indicate the alarm had been
triggered.
The system's LED will also flash in pulses to indicate which input triggered the alarm.
NOTE: :LED status will be cleared when ignition is turned ON. For proper memory clearing, insure that Ignition #1 is
connected to ignition on vehicle
IG2
IG1
Cut
Start
ON BOARD STARTER KILL RELAY
SPADE CONNECTORS
IG2
IG1
Start
Start
87
86
Orange
On Steady
Not in Reservation Mode
Tach Lockout
DIAGNOSTIC IN MEMORY
Door Trigger Input
Hood Input
Brake Pedal
No Tach Signal
x
Cut
x
87a
85
30
Yellow
Led
Hood Open
Door Input Shutdown(manual)
Brake Pedal Active
In Valet Mode
Manual Transmissions Only
No Tach signal detected or Not tach learned
Notes:
Door Input Shutdown(manual)
Hood Open
Brake Activated
No tach detected during crank or correct
tach not programmed
Led will come on for 2 seconds when door is opened
or shock is triggered
Shock Sensor Triggered Alarm
Ignition was turned on while Alarm was armed
Hood Input was Triggered while alarm was armed
Brake was triggered while alarm was armed
SYSTEM IN VALET MODE
Fault

Advertisement

Table of Contents
loading

This manual is also suitable for:

1000 series

Table of Contents