Table of Contents
Advertisement
VS Omni Pump
Owner's Manual
SAVE THIS INSTRUCTION MANUAL
Hayward Pool Products
620 Division Street, Elizabeth NJ 07207
Phone (908)-355-7995
www.hayward.com
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Contents
Pump Warnings...............2
Overview.........................5
Installation......................7
Operation......................10
Troubleshooting............11
Maintenance.................12
Warranty........................13
Registration Card...........15
092708 RevA
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Hayward TriStar VS 950 Omni
Summary of Contents for Hayward TriStar VS 950 Omni
-
Page 1: Table Of Contents
Registration Card...15 TriStar VS 950 Omni Tristar VS 900 Omni Super Pump VS 700 Omni MaxFlo VS 500 Omni SAVE THIS INSTRUCTION MANUAL Hayward Pool Products 620 Division Street, Elizabeth NJ 07207 Phone (908)-355-7995 www.hayward.com USE ONLY HAYWARD GENUINE REPLACEMENT PARTS... -
Page 2: Pump Warnings
All electrical wiring MUST be in conformance with all applicable local codes, regulations, and the National Electric Code (NEC). USE OF NON-HAYWARD REPLACEMENT PARTS VOIDS WARRANTY. ATTENTION INSTALLER - THIS MANUAL CONTAINS IMPORTANT INFORMATION ABOUT THE INSTALLATION, OPERATION, AND SAFE USE OF THIS VARIABLE SPEED PUMP THAT MUST BE FURNISHED TO THE END USER OF THIS PRODUCT. - Page 3 Mechanical Entrapment - There is potential for jewelry, swimsuits, hair decorations, fingers, toes, or knuckles to be caught in an opening of a suction outlet cover resulting in mechanical entrapment. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
- Page 4 It is also necessary to allow the motor to cool for at least 20 minutes prior to maintenance to minimize the risk for burns. WARNING – Failure to install according to defined instructions may result in severe personal injury or death. SAVE THESE INSTRUCTIONS USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
-
Page 5: Overview
0.4 - 10.0 amps Speed Range: 600 - 3450 RPM Horsepower: 1.65 hp MaxFlo VS 500 Omni Voltage: 230 VAC, 60Hz, Single Phase Amps: 0.4 - 10.0 amps Speed Range: 600 - 3450 RPM Horsepower: 1.65 hp USE ONLY HAYWARD GENUINE REPLACEMENT PARTS... - Page 6 Operate the pump at higher speeds for the shorter periods of time needed to operate a heater, water feature, etc. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
-
Page 7: Installation
Fittings (elbows, tees, valves, etc.) restrict flow. For better efficiency, use the fewest possible fittings. Avoid fittings that could cause an air trap. Pool and spa fittings MUST conform to the International Association of Plumbing and Mechanical Officials (IAPMO) standards. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS... - Page 8 TriStar VS 950 Omni Wiring Connections Both the high voltage input power and the low voltage communication cable need to be connected to the TriStar VS 950 Omni pump. Both connections are ac- cessible in the drive wiring compartment found underneath the cover plate. Refer to the following steps when wiring the TriStar VS 950 Omni.
- Page 9 2. Low Voltage Wiring - Wiring connections for the TriStar VS 950 Omni are shown below. When wiring the low voltage communication cable, refer the to table below. One conductor will go from screw terminal “2” on the VS Omni Hub to screw terminal “7” on the TriStar VS 950 Omni pump. The other conductor will go from screw terminal “3”...
-
Page 10: Operation
Have a professional perform this test. Ensure all Hayward pump and system components are removed from system prior to performing test. WARNING – If circulation equipment must remain in the plumbing system during water pressure test, do not apply more than 10 psi pressure to the system. -
Page 11: Troubleshooting
• Re-check the strainer housing cover and all threaded connections for suction leaks. Check if all system hose clamps are tight. • Check voltage to ensure that the motor is rotating at full rpm’s. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS... -
Page 12: Maintenance
If needed, additional detailed information is available for your pump. The manuals can be found online and show shaft seal replacement instructions, stand alone pump operation (when not connected to VS Omni,), and more. To find the appropriate manual for your VS Omni pump, go to Hayward.com use the cross referenced using the part numbers shown below. -
Page 13: Tristar Vs 950 Omni
Replacement Parts TriStar VS 950 Omni USE ONLY HAYWARD GENUINE REPLACEMENT PARTS... -
Page 14: Tristar Vs 900 Omni
TriStar VS 900 Omni USE ONLY HAYWARD GENUINE REPLACEMENT PARTS... -
Page 15: Registration Card
Super Pump VS 700 Omni USE ONLY HAYWARD GENUINE REPLACEMENT PARTS... -
Page 16: Maxflo Vs 500 Omni
MaxFlo VS 500 Omni USE ONLY HAYWARD GENUINE REPLACEMENT PARTS... - Page 17 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
- Page 18 TriStar VS 950 Omni Limited Warranty ® To Buyer, as original purchaser of this equipment, Hayward Pool Products, Inc. warrants this product to be free from defects in materials and workmanship for a period of FOUR (4) years from the date of purchase.
- Page 19 Please include me on all e-mail communications regarding Hayward Equipment or promotions. ® Mail to: Hayward Pool Products, 620 Division Street, Elizabeth, NJ 07207 Attn: Warranty Dept or REGISTER YOUR WARRANTY ON-LINE AT WWW.HAYWARD.COM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
- Page 20 Hayward is a registered trademark and VS Omni is a trademark of Hayward Industries, Inc. © 2017 Hayward Industries, Inc. All other trademarks not owned by Hayward are the property of their respective owners. Hayward is not in any way affiliated with or endorsed by those third parties.
Need help?
Do you have a question about the TriStar VS 950 Omni and is the answer not in the manual?
Questions and answers