Table of Contents
Advertisement
LiPo/LiIo/LiFe Battery Discharge Setup
Select Program→Discharge to enter Discharge setup interface.
Note: 1. The charger first discharges with constant current (CC) according to the user setting then turns
to constant voltage (CV) when it reaches the discharge voltage. In the CV phase the current
gradually falls, and the charger will terminate discharging when the current falls below the
percentage of the configured discharge current.
2. Regenerative mode has three available settings: OFF, To input, To channel, see more details on
Page38
Important
To Channel Setup
When selecting to To channel on Regenerative Mode, "
and click to enter To channel setup interface, after setting click "
Note: For example, a 12V/60W bulb as the load of To Channel, it should set Voltage Limit =12V；Current
Limit=60/12=5A.
LiPo/LiIo/LiFe Battery Discharge Advanced Setup
Click "
" to enter LiPo/LiIo/LiFe Battery DISCHARGE ADVANCED SETUP interface, after setting
click"
" to return to the previous interface.
Note: 1. Tick Extra Discharge Enable to activate discharge enable, see more details on Page39
Battery Extra Discharge
2. Tick Balance Enable to activate balance discharge; when discharge enters the CV phase, it
starts to balance the cell voltages.
LiPo/LiIo/LiFe Battery Discharge Safety Setup
Click "
" to enter DISCHARGE SAFETY SETUP interface, see details about setting on Page19 LiPo/LiIo/LiFe
Battery Charge Safety Setup.
Notes.
Mode.
- 20 -
Synchronous Balance Charger/Discharger
Discharge Current:
0.05A-30A; default: 2A
Discharge Voltage:
3V/Cell-4.1V/Cell;
Default: 3.5V/Cell
End Current:
1%-100%; default: 50%
Regenerative Mode:
OFF (default), To input,
To channel
"button changes from inactive to its operational status,
" to return to the previous interface.
Channel Join:
Not available
Voltage Limit:
0.1V-40V; default: 12V
Current Limit:
0.05A-30A; default: 1A
308DUO V1.1.0
Lithium
- Quick Links:
- Icharger Charge/Discharge Setup & Use
Hide quick links:
Advertisement
Table of Contents
