LiPo/LiIo/LiFe Battery Cycle Setup
Select Program→Cycle to enter Cycle setup interface, after setting click"
LiPo/LiIo/LiFe Battery Only Balance Feature
Select Program→Balance Only to enter Balance Only setup interface, after setting click"
interface.
Note: Balance Only is the program only to equalize the individual cells through balance port to reduce
the voltage difference.
NiMH/NiCd Battery Charge/Discharge Setup
After adding a program, it will switch to NiMH/NiCd battery in Type option on the MEMORY SETUP interface. Set the
Capacity, the number of cells for NiMH/NiCd battery cannot be set, and the charger sets Auto by default, after editing
all parameters for the program, click"
As shown in above picture, the program of NiMH, NiCd has the following modes: Charge, Discharge and Cycle.
NiMH/NiCd Battery Charge Setup
Select Program→Charge to enter Charge setup interface.
Note: Charge Mode has Normal and Reflex modes available; use reflex mode to charge the battery, it
can reduce the heat in the battery; please see charging principle on Page38
Cycle Mode:
Cycle Count:
Delay Time:
" to save and return to the previous interface.
Chg Current:
Chg Mode:
- 21 -
Synchronous Balance Charger/Discharger
" to return to the previous interface.
CHG→DCHG (default);
DCHG→CHG
1-99; default: 3
0Min-9999Min; default: 3Min
0.05A-30A; default: 2A
Normal (default), Reflex
308DUO V1.1.0
" to return to the previous
Important
Notes.