308Duo Parameters Setup; Charger Setup; Temp. & Fans Setup - iCharger 308DUO User Manual

308DUO Parameters Setup

 308DUO Parameters Setup
Press TAB/SYS button for 2 seconds on the initial interface to enter the SYSTEM MENU interface, setting and testing of
the system parameters, storage and servo can be completed on this interface.
1
2
3
4
5
6
7
8
9
10
 Charger Setup
After setting all parameters, click "

Temp. & Fans Setup
Select SYSTEM MENU→Charger Setup→Temperature&Fans to enter the setup interface, after setting click "
save and return to the previous interface.
Note:
When the charger's internal temperature reaches the ON Temperature, the fan will start
automatically to dissipate heat, and adjust speed automatically depends on the temperature
increasing or decreasing. When the temperature exceeds the Power Reduce temperature, the
charger will stop increasing (temp. shown in orange) by reducing the highest power limit. When the
temperature reaches Shut Down temperature, the charger will shut down. [When temp. >Shut
Down-3, the temperature is shown flashing in red]
Temperature, the fan will keep running within the setting time of OFF Delay Time.
11
12
13
14
" to save and return to the previous interface.
- 26 -
Synchronous Balance Charger/Discharger
1: Charger Setup Menu
2: Temp. & Fans Setup
4: LCD Setup
6: Power Supply Setup
7: Save & Load Configuration Setup
8: Calibration Setup
10:Calibration
11: Extra- Function
12: Log Files Manage
14: Pulse Test
1: Temperature:
Unit: Celsius(default),Fahrenheit
℃
Shut Down: 60 -75
℃
Power Reduce: 5 -20
2:Cooling Fans:
ON Temperature:
℃ ℃
30 -50 ;default:40
OFF Delay Time:
0Min-10Min;default:2Min
.
When the temperature is lower to the ON
308DUO V1.1.0
3: Beep Tone Setup
5: Output Power Setup
9:Language Setup
13: Servo Test
℃ ℃
;default:75
℃ ℃
;default:10
℃
"to