Weighing System; Ground Operations; Machine Start-Up - Haulotte HA12PX Operator's Manual

12 to 26m engine-powered articulated lifts
E
- Driving

3.1.4 - Weighing system

3.2 - GROUND OPERATIONS

3.2.1 - Machine start-up

Petrol/gas For : HA16PX (HA46JRT)-HA18PX (HA51JRT)
Petrol/gas changeover While the engine is running :
• Open the gas bottle valve.
• Set the fuel selector ( P23 ) to Gas.
Gas/petrol changeover While the engine is running :
• Set the fuel selector ( P23 ) to petrol.
• Close the gas bottle valve.
You can switch between petrol and gas using the selector ( P23 ) :
• The ( LPG (P23) ) indicator is on, showing that the machine is set to gas mode.
• The petrol indicator ( P23 ) is on, the machine is in petrol mode.
N.B.-:-I
F THE MACHINE STALLS WHEN YOU CHANGE FUEL SOURCE
ENGINE AND BEGIN THE START UP PROCEDURE AGAIN
After several attempts have been made to start up, a bang can be heard inside the silencer,
but this does not represent any danger. This bang is caused by a build-up of unburnt gas.
basic principles : While the engine is running : If the temperature is below 0 °C (0 °F), you are
advised to start up the machine in LPG version
. To start up in petrol mode, you are advised to pull the starter half out to aid start up during
first usage
74 24203 3237 0
1. Pull the emergency stop push buttons P15, P46.
2. Switch the machine on P72. Upper console platform overload LED ( P30 ) flashes.
1. Pull the emergency stop push button P15.
2. Switch the machine on P72.
3. Turn the key of the console activation selector ( P72 ) to the right to activate the lower
console. The following LEDs are switched on :
• Low engine oil pressure P2.
• Engine temperature P3.
• Battery charge P4.
4. The clogged air filter LED ( P5 ) is switched off.
5. Press on the starter selector P22. The engine starts. The LEDs switch off.
6. Let the engine heat up.
,
.
E 09 07
PRESS THE PUSH BUTTON TO STOP THE
EN