Datatool S4 Series Training Manual page 54

Coding new transmitters, changing siren tones, passive arming selection and movement/shock adjustment
It will not be possible to follow the procedures below without first having registered a PIN number to the alarm system
Enter PIN number (after last number has been entered a long tone will be heard)
Turn ON Ignition switch then press Grey button on a new or existing transmitter
If new transmitter - (The new transmitter will now have been coded to the alarm)
If only programming a new transmitter leave the ignition switch off for at least 15 seconds
To proceed to siren tone or passive arming section (Software Switches) turn Ignition back ON
Software Switch number
Toggle to desired Switch
Switch 1 (For customer use)
Change siren tones
Press Grey button to toggle to
switch 2 &3
(Alarm will beep once to confirm
switch number)
Switch 2 (For customer use)
Alarm arming method
(Alarm will beep twice to confirm
switch number)
Switch 3
(For dealer use only)
Entry to Engineer Switches
Switch 3 Allows the dealer to access
a further 8 Engineer Switches
Press Black button to toggle to
switch 2 & 1
(Alarm will beep three times
to confirm switch number)
Press Grey button on transmitter or enter PIN number to disarm alarm
Turn Ignition switch ON, OFF, ON, OFF, ON (within 7 seconds)
Turn OFF Ignition switch (Two tones will be heard)
Within 15 seconds of hearing these tones
Press buttons as shown below
to enter desired Switch
Press
Press
Unlike the customer selectable
Switches, Switch 3 can be
thought of as a trap door
allowing access to the dealer
only part
programming,
known as Engineer Switches
To enter switch 3 press the
transmitter
sequence shown on the right.
This will take you directly to
Engineer Switch 1
Method of altering setting and accepting
To exit Software switches at any time turn Ignition
Press Both buttons to save and exit back to switch selection
Black button/LED OFF = Passive Immobiliser
Press Both buttons to save and exit back to switch selection
of the alarm
otherwise
buttons in the
A single lower tone will be heard to confirm entry to
Annex 2
switch off for at least 15 seconds
Grey button = Next tone
Black button = Previous tone
Grey button/LED ON = Full passive arming
(Default)
Press Both buttons
Press Grey button
Press Both buttons
Press Black button
Engineer Switch 1