Siemens MOBILETT Plus Service Instructions Manual page 88

10 - 10
•
Tighten screws (2) and (3).
•
Tighten the adjustment screw until the arm and single tank are held in the uppermost
position by the spring force alone.
MOBILETT Plus and Plus M only
The installation of the turn plate is performed in the reverse order.
•
Install the turn plate.
•
Reattach the shafts.
•
Reattach the bearing rings.
•
Reattach the locking rings.
•
Connect the ground cable and K68.
All MOBILETT:s
•
Reinstall the supporting wheels behind the tilt bar.
•
Reattach the tilt bar.
•
Remove the ceiling support carefully and check that the single tank remains in the
uppermost position by itself. If not, tighten the adjustment screw.
•
Move the arm into the park position.
•
Lower the unit to the floor and block the rear wheels.
•
Check the arm and single tank movement. If necessary, adjust according to section
"Adjustment of the arm system".
•
Reattach all covers except the top cover.
•
Set switch S10 in the ON position to charge the capacitor bank.
•
Reattach the top cover.
•
Check the function of the turn plate and the unit by releasing one exposure.
MOBILETT Plus / - E/ - M SPR8-215.898.01
Rev. 05 01.02
Mechanical systems
Page 10 of 28 Siemens-Elema AB
SPS-UD Solna, Sweden