Cabletron Systems 3Com PortSwitch Hub Manual page 43

Device Events and Alarms
Table 4-1. 3Com PortSwitch Hubs Events and Alarms (Continued)
CsEvFormat/Event00ea0061
{d "%w- %d %m-, %Y - %T"} A 3Com
Hub, {t} (name {m}) reports that the
managed agent has recieved a reply to a
poll after a sequence of four or more un-
successfull polls. The addres is {S 1}
with protocol {T pprot 3}. (event [{e}])
CsEvFormat/Event00ea0062
{d "%w- %d %m-, %Y - %T"} A 3Com
Hub, {t} (name {m}) reports that the
managed agent has not recieved a reply
to a poll after a sequence of four un-
successfull polls. The address is {S 1}
with protocol {T pprot 3}. (event [{e}])
CsEvFormat/Event00ea0063
{d "%w- %d %m-, %Y - %T"} A 3Com
Hub, {t} (name {m}) reports that the
Resilient Backup Power Supply
connected to this repeater has
developed a fault. (event [{e}])
CsEvFormat/Event00ea0064
{d "%w- %d %m-, %Y - %T"} A 3Com
Hub, {t} (name {m}) reports that the
Resilient Backup Power Supply
connected to this repeater has
recovered from a fault. (event [{e}])
CsEvFormat/Event00ea0066
{d "%w- %d %m-, %Y - %T"} A 3Com
Hub, {t} (name {m}) reports that a port
{I 2} has seen an unrecognised MAC
address and is doing the following
action {I 1} (2=Notify, 3=Disconnect).
(event [{e}])
CsEvFormat/Event00ea0067
{d "%w- %d %m-, %Y - %T"} A 3Com
Hub, {t} (name {m}) reports that a
repeater {I 2} has had its Bandwith
Used threshold {I 3} exceeded. The
Bandwith used is {I 1} (event [{e}])
Event and Alarm Messages
4-10
Message in the Event Log Alarm View Probable Cause
Message
No Probable cause message.
No Probable cause message.
No Probable cause message.
No Probable cause message.
No Probable cause message.
No Probable cause message.
3Com PortSwitch Hubs
Management Module Guide