Lightspeed TOPCAT Registration Manual page 3

TOPCAT ACCESS REGISTRATION GUIDE
STANDARD REGISTRATION
REPLACING A FLEXMIKE (NO OTHER REGISTRED COPONENTS IN PLACE)
For users replacing a lost or malfunctioning Flexmike.
1. Start with the Topcat plugged in and powered on. To verify it is powered on,
there will be a blue power light on the front of the Topcat.
2. Power on the new Flexmike. Both microphone 1 and 2 blue lights should start
blinking.
3. When replacing a Flexmike, make sure the malfunctioning unit is powered off.
4. Open the Flexmike battery compartment and pull the
battery out (leaving it plugged in) to reveal the registration
button.
5. Open the speaker panel of the Topcat (see Topcat Install Guide for instructions on how to open the panel). The Topcat can remain
installed for this process.
6. Using a paperclip with the end straightened
begin blinking on the Topcat.
TONE
TREBLE
BASS REGISTER
MICROPHONE
MIN
MAX
7. Briefly press the registration button on the Flexmike. The 1 and 2 lights will
start blinking alternately.
8. After several seconds, the #1 light on the Topcat will turn solid and the #1 light
on Flexmike will remain blinking, then turn solid.
9. The registration is complete. You can begin speaking into the new Flexmike to
verify there is audio.
10. Place system ID number (attached to the Topcat Daily Use Guide) on the new
Flexmike.
NOTE: if at any point, the Topcat or Flexmike lights begin blinking rapidly, that
indicates a registration error. Turn the new Flexmike off and repeat steps 4-9.
Blinking lights
out, briefly press the registration button on the inside of the Topcat. The 1 and 2 lights will
MIN MAX
PAGEFIRST
SENSITIVITY
AUDIO IN
MIN
MAX
Power On
(NEW Flexmike)
Solid light
Registration
Button
Blinking lights
Registration ID Labels
Apply to system components to indicate which parts are registered
as a system. Keep registered items together when storing away.
Solid lights
334-0162-02-00-01
00-01 00-01 00-01
00-01
00-01 00-01
00-01
00-01 00-01 00-01
00-01
00-01 00-01
00-01
00-01
00-01 00-01
00-01
00-01
00-01 00-01
00-01
RETAIN EXTRA LABELS IN THE EVENT A COMPONENT IS REPLACED OR ADDED.
10101
00-01
00-01
00-01
00-01
00-01
00-01