Figure 61. Installing the 2.5-inch drive backplane
Next steps
1.
Install the
drives.
2. Connect the drive backplane cables to the connector on the backplane.
3.
Install the cooling fan cage.
4.
Install the front PERC module.
5. Follow the procedure listed in
Drive bays
Removing the drive bay cage blank
Prerequisites
1. Follow the safety guidelines listed in the
2. If installed,
remove the front bezel.
Steps
Using a flat head screwdriver, remove the drive bay cage blank.
NOTE:
The procedure to remove the drive cage blanks are similar.
After working inside your
Safety
instructions.
system.
Installing and removing system components
69