Removing The Internal Usb Module; Installing The Internal Usb Module - Dell EMC PowerEdge T550 Installation And Service Manual

Removing the internal USB module

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3. Remove the air shroud.
4. If you are replacing the internal USB module,
Steps
Holding the blue pull tab, lift the internal USB module out of the system.
Figure 120. Removing the internal USB module
Next steps
Replace the internal USB

Installing the internal USB module

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3. Remove the air shroud.
Steps
1. Locate the internal USB connector on the system board.
NOTE: For information on the exact location of internal USB on system board, see
section.
2. Align internal USB module with the connector on the system board.
3. Press the internal USB module until firmly seated on the system board.
118 Installing and removing system components
Safety instructions.
Before working inside your
remove the internal USB
module.
Safety instructions.
Before working inside your
system.
key.
system.
System board jumpers and connector