Optional Serial Com Port; Removing The Serial Com Port - Dell EMC PowerEdge T550 Installation And Service Manual

6. Align the OCP air shroud to the guide pins on the chassis and lower the OCP air shroud.
Figure 156. Installing the OCP air shroud.
Next steps
1. Install the air shroud.
2. Follow the procedure listed in

Optional serial COM port

This is a service technician replaceable part only.

Removing the serial COM port

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3. Remove the air shroud.
4. Disconnect the cable connected to the serial COM port.
Steps
1. Open the blue latch and slide the serial COM port out of the system.
After working inside your
Safety instructions.
Before working inside your
system.
system.
Installing and removing system components 151