Installing The Power Interposer Board - Dell EMC PowerEdge T550 Installation And Service Manual

Figure 174. Removing the PIB
Next steps
Replace the power interposer

Installing the power interposer board

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3. Remove the air shroud.
4. Remove the PSU.
Steps
1. Align the screw holes on the power interposer board (PIB) with the holes on the system.
2. Using the Phillips 2 screwdriver, secure the PIB to the system using the screws.
3. Connect all the disconnected power cables to the PIB.
board.
Safety instructions.
Before working inside your system.
Installing and removing system components 163