Removing A Power Supply Unit Blank; Installing A Power Supply Unit Blank - Dell EMC PowerEdge T550 Installation And Service Manual

Removing a power supply unit blank

Prerequisites
Follow the safety guidelines listed in the
Steps
Pull the blank out of the system.
CAUTION: To ensure proper system cooling, the PSU blank must be installed in the second PSU bay in a
non-redundant configuration. Remove the PSU blank only if you are installing a second PSU.
Figure 163. Removing a 60 mm power supply unit blank
Figure 164. Removing a 86 mm power supply unit blank
Next steps
Replace the PSU blank or

Installing a power supply unit blank

Prerequisites
1. Follow the safety guidelines listed in the
NOTE: Install the power supply unit (PSU) blank only in the second PSU bay.
2. If required, remove the
Steps
Align the PSU blank with the PSU bay and push it into the PSU bay until it clicks into place.
Safety instructions.
install the PSU.
Safety
PSU.
instructions.
Installing and removing system components 157