Removing The Boss S2 Card Carrier - Dell EMC PowerEdge T550 Installation And Service Manual

Figure 112. Installing the BOSS S2 module
Figure 113. Installing the BOSS S2 module
Next steps
1. Connect the cables to the system board connectors.
NOTE: Route the cables properly to prevent them from being pinched or crimped.
2. If removed, install the front
3. Install the air shroud.
4. Follow the procedure that is listed in

Removing the BOSS S2 card carrier

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
114 Installing and removing system components
bezel.
After working inside your
Safety instructions.
Before working inside your
system.
system.