Installing The Serial Com Port - Dell EMC PowerEdge T550 Installation And Service Manual

Figure 157. Removing the serial COM port
2. Install the filler bracket if not replacing the serial COM port.
Next steps
Replace the serial COM port.

Installing the serial COM port

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3. Remove the air shroud.
Steps
1. Open the blue latch and remove the filler bracket from the system.
2. Slide the serial COM port and close the blue latch, until it snaps into place.
Figure 158. Installing the serial COM port
Next steps
1. Connect the cable to serial COM port.
152 Installing and removing system components
Safety instructions.
Before working inside your system.