Setting Of Numeric Parameter (Numeric Param.); Numerical Parameter Composition; Initialization Of Set Value (Clear); Overview - Canon Super G3 FAX Board-AR1 Service Manual

5
Service Mode Service Mode > Initialization of Set Value (CLEAR) > Overview

Setting of Numeric Parameter (NUMERIC Param.)

Sssw Menu Num Ncu Type IPFAX
<NUM> <1/4>
xxxxx
001
002 xxxxx
003 xxxxx
xxxxx
004
005 xxxxx
006 xxxxx
007 xxxxx
008
xxxxx

■ Numerical Parameter Composition

No. Function
01 Missing areas of printing image when receiving
image with longer length than standard
04 Leading edge blank area
05 Trailing edge blank area
001: printing upon reception of extra-length image
Use it to set the range of the image to be removed from when printing an extra-length
received image.
Lower the parameter to decrease the range if the trailing edge of the received image must be
retained (as when it is longer than the effective recording length).
004: leading edge margin
Use it to set the leading-edge margin for the effective recording length.
005: trailing edge margin
Use it to set the trailing-edge margin for the effective recording length.
5 Service Mode > Initialization of Set Value (CLEAR) > Overview Service Mode
Print Clear Test Report
<READY>
←（yyyyy）{aaaaa～bbbbb}
←（yyyyy）{aaaaa～bbbbb}
←（yyyyy）{aaaaa～bbbbb}
←（yyyyy）{aaaaa～bbbbb}
←（yyyyy）{aaaaa～bbbbb}
←（yyyyy）{aaaaa～bbbbb}
←（yyyyy）{aaaaa～bbbbb}
←（yyyyy）{aaaaa～bbbbb}
OK
F-5-13
Setting range Initial setting Unit
0 to 9999 12 1 mm
0 to 9999 3 1 mm
0 to 9999 3 1 mm
T-5-22

Initialization of Set Value (CLEAR)

Overview

You can select and initialize data by making the following selections; as a result, settings and
various parameter values will be reset to the factory settings.
Item Data to be initialized
TEL telephone number registration data (*1)
USSW SW user data and data registered under Service Mode #1 through #3.
of user data, the memory management data will not be deleted.
image data collected in memory will not be deleted.
SRV SW user data and data in Service Mode #1 through #3, #7.
NCU data under Service Mode #4.
SRV DATA system dump list data.
REPORT communication control report data.
ALL all settings/registered data (*1) except data under Service Mode #5 TYPE (*2).
COUNTER number of prints, number of sheets read.
*1: If the model is capable of storing addresses other than fax addresses, the telephone
number data will not be deleted upon execution of 'TEL' and 'ALL'.
To remove the telephone number data, use the host machine's service mode: COPIER
> FUNCTION > CLEAR > ADRS-BK.
*2: When 'ALL' is executed, the values suited to the destination of the machine will be
stored under 'TYPE'; in the case of Japan, 'standard'.
5-15
T-5-23
5-15