Menu Items - Canon Super G3 FAX Board-AR1 Service Manual

5
Service Mode Service Mode > Outline > Menu Items
For instance, in the case of #1 SSSW, the following holds true; key functions and operations
are the same for all screens:
Menu Num Ncu Type
Sssw
SW01 00000000
SW02
10000000
SW03 00000000
SW04
10000000
SW05 00000000
SW06
10000000
SW07 00000000
SW08
10000000
Previous Page/Next Page key
• If you want to change 0 to 1 or 1 to 0 on a bit switch, press the desired bit (number) directly.
• If you want to store a change or execute an item, press the OK key.
• Use the keypad to enter a numerical value.
• To return to the previous level of selection, press the Reset key.
Caution:
If you changed a setting in service mode, be sure to turn off and then on the power
(making sure that you first turn off the control panel switch and then the main power
switch).
The settings made in service mode are stored on the hard disk. The settings associated
with the Board are loaded to the G3 fax control PCB only when the main power is tuned
on, thus requiring you to turn it off and then on after making a change.
5 Service Mode > Outline > Menu Items Service Mode
ISDN Print Clear Test Report
<READY>
<1/7>
OK
Press to accept the current input.
F-5-2

Menu Items

#1 SSSW SW01 error management
SW02 Not used
SW03 set remedy against echo
SW04 set remedy against communication error
SW05 set standard function <DIS signal>
SW06 to SW08 Not used
SW09 set communication result display
SW10 to SW11 Not used
SW12 set page timer
SW13 Not used
SW14 Inch/mm resolution settings
SW15 to SW24 Not used
SW25 set report display function
SW26 set transmission function
SW27 Not used
SW28 set V. 8/V. 34
SW29 Not used
SW30 Dial tone detection method switching
SW31 to SW50 Not used
#2 MENU 001 to 004 Not used
005 NL equalizer
006 line monitor
007 transmission level (ATT)
008 V.34 modulation speed upper limit
009 V.34 data speed upper limit
010 to 020 Not used
#3 NUM 001 not used
002 RTN transmission condition (1)
003 RTN transmission condition (2)
004 RTN transmission condition (3)
005 NCC pause time (before ID code)
006 NCC pause time (after ID code)
007 pre-pulse time at time of call
008 not used
009 number of characters in telephone numbers between
transmitting and receiving parties.
010 line connection identification time
011 T.30 T1 timer (for reception)
012 not used
013 T.30 E0L timer
014 to 026 not used
015 hooking detection time
027 preamble detection time for V.21 low-speed flag
028 to 080 not used
5-3
F-5-3
F-5-4
F-5-5
5-3