Table of Contents
Advertisement
Chapter 2 Preparations
Installation
1.13.3
Install a riser card to a PCI card in the following procedure.
1.
Refer to steps 1 to 6 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
Remove the screw securing the PCI riser
card. Hold the both ends of the PCI riser
card and lift it off.
3.
Confirm the installation position with the reference to the table on 1.14.2 Supported boards and
available slots.
4.
Remove the screw from the PCI riser
card and remove the blank cover.
5.
Install a PCI card to the PCI riser card.
When installing the card, position the
terminal part of the PCI card to the PCI
riser card slot and insert it.
Important
When installing a PCI card, make sure the connector of the board fits the
connector of the riser card.
Note
• Check the board type (Low Profile or Full Height) which respective riser card
supports and the type of PCI card to be installed.
• If the battery for RAID controller is installed, refer to Chapter 2 (1.11 Battery for
RAID Controller).
Note
Keep the removed blank cover for future use.
Important
Do not touch the terminal part of riser card or PCI card and the signal pins
of electric parts installed on the board. Installing boards with dirt or oil can
cause malfunction.
Note
• Make sure that the head of a PCI card bracket is seated into the fixed slot.
• Depending on type of PCI cards, the terminal part of the PCI card may be too
large to fit in the connector.
• If you have trouble installing the card, remove the card once and try again. If you
apply excessive pressure on the card, a PCI card or riser card might break.
Express5800/R120d-1M User's Guide
1. Installing Internal Optional Devices
PCIe #1C
Low profile side
PCIe #1B
Full Height side
81
Advertisement
Table of Contents
