Table of Contents
Advertisement
Chapter 2 Preparations
3.
When the server is pushed into the rack and
is locked, push the server to the end while
pulling the release levers (blue) on both
sides of the server.
4.
Push the server until its lock on front panel
clicks.
(2)
Removal procedure
Remove the server from the rack in the following procedure.
1.
Make sure that the server is turned off and then disconnect the power cord or all interface cables from
the server.
2.
Remove the front bezel.
3.
Slowly pull the server out while pressing the
buttons located on either side of the front of
the server.
Important
At least two persons are required to remove the server from rack.
Express5800/R120d-1M User's Guide
2. Installation and Connection
Release lever
Press the button
to unlock
107
Advertisement
Table of Contents
