Troubleshooting; Recycling And Disposal - Nakayama MB2100 Manual

Manual (63 pages)

Table of Contents

Available languages

Troubleshooting

Suspected malfunctions are often due to causes that the users can fix themselves. Therefore check the product using this section. In most cases the problem

can be solved quickly.

WARNING! Only perform the steps described within these instructions! All further inspection, maintenance and repair work must be performed by an au-

thorised service centre or a similarly qualified specialist if you cannot solve the problem yourself!

Problem

1. Product does not start

2. Product does not reach full power

3. Unsatisfactory result

4. Excessive vibration or noise

Recycling and disposal

The product comes in a package that protects it against damage during shipping. Keep the package until you are sure that all parts have been deliv-

ered and the product is function properly. Recycle the package afterwards.

WEEE symbol. Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your

Local Authority or local store for recycling advice.

* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes significantly affect the performance and safety of

the products. The parts described / illustrated in the pages of the manual that you hold in your hands may also concern other models of the manufacturer's product line with similar features and may not be

included in the product you just acquired.

* Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is used in commercial, trade or industrial businesses

or for equivalent purposes.

* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement work, including maintenance and special adjustments, must only be carried out by

technicians of the authorized service department of the manufacturer.

Possible cause

1.1. Not connected to power supply

1.2. Power cord or plug is defective

1.3. Other electrical defect to the product

2.1. Power source (e.g. generator) has too low

voltage

2.2. Air vents are blocked

3.1. Tines are dull/damaged

3.2. Tines not suitable for ground material

4.1. Tines are dull/damaged

4.2. Bolts/nuts are loose