Filter Frames; Anti-Glare Shields - SGM Q Series User Manual

Filter frames

The Q-8 features various optional, magnetic holographic filter frames such as elliptical diffusers:
To install them, it is only required to position the filter frame in front of the light, and it quickly snaps into place.
The frames are fitted with a safety wire to secure the frame to the handle of the Q-8.
A filter frame and barndoor can both be mounted and working together on the same fixture.
Filter frame front view
PLEASE NOTE!!
The barndoors and the filter frames are not intended for permanent outdoor installations.

Anti-glare shields

The Q-8 supports two different types of optional anti-glare shields:
• Full anti-glare shield - covers the full fixture's opening
• Half anti-glare shield - covers half of the fixture's opening
Using the anti glare shields will remove any unwanted glare and reflections.
The anti glare shields are easily mounted by removing the two tilt lock bolts, one in each side of the fixture. Refit the anti glare
shield in position and screw both tilt locks bolts again.
Note: The anti-glare shields are suitable for both permanent outdoor and indoor installations.
For further information and other possibilities visit www.sgmlight.com or contact your local SGM dealer.
16
Filter frame back view
Figure 21: Q-8 Filter frames
Figure 22: Full and half anti-glare shields
Q-8 with lter frame