Q-8 Connection Diagram; Using Standalone Operation; Setting A Static Color Manually - SGM Q Series User Manual

Q-8 Connection Diagram

115 - 277V AC
50-60 Hz
630 W

Using standalone operation

The fixture can be pre-programmed to perform a series of up to 24 scenes, which the fixture will be playing in a continuously loop.
Up to three stand-alone programs can be defined and run from the menus, and one of the programs can be set to run by default
whenever the fixture is powered on.
Each of the three available stand-alone programs contains 24 user-
definable scenes with its own RGB and shutter settings.
Each scene has a definable fade-in time for the transition from one color
to the next, and a wait (static) time of up to 120 minutes and 59 seconds.
To define a stand-alone program, press ENTER → MANUAL → EDITOR.
The standalone mode of the fixture's startup is enabled by selecting:
ENTER → SETTINGS → STARTUP MODE → SELECT STARTUP MODE
→ STANDALONE.
To select the fixture's startup program, press:
ENTER → SETTINGS → STARTUP MODE → STARTUP PROGRAM.
The chosen program will run its length cyclically whenever the fixture is
powered on.
To run an internal program, go to:
ENTER → MANUAL → RUN PROGRAM.
To stop an active internal program, go to:
ENTER → MANUAL → STOP
PLEASE NOTE
The fixture will not be playing the preprogrammed scenes if it is receiving DMX signal

Setting a static color manually

The Q-8 can be configured to display a predefined and static color.
To set up a static color select ENTER → MANUAL → QUICK COLOR EDITOR. Note that, once the MANUAL → QUICK COLOR
EDITOR when the settings are changed, the fixture is set, by default, to automatically start in quick color mode whenever it is
powered on. This can be reset through the menu SETTINGS → STARTUP MODE → SELECT STARTUP MODE.
The current quick color program can always be stopped by selecting MANUAL → STOP PROGRAM in the menu.
See "Control menu" on page 13 for detailed information about the manual menu.
1
Q 8
Max. 5 units/16 A circuit
Figure 11: Q-8 connection diagram
PROGRAM.
2
Q 8
115 - 277V AC
50-60 Hz
630 W Max. 32 units/DMX line
xx
Q 8
115 - 277V AC
50-60 Hz
630 W
120 Ohm +/- 5%
Figure 12: Standalone operation
11