Wallbeds Australia AB-6 Assembly Instructions Manual page 4

Cupboard & drawer

Cam Pins Insert all Cam Locks into the following panels as described by the cabinet part located

on the cabinet sticker.

End

Pull Out Drawer / Table Runners –

Attach the runners before assembling the cabinetry.

Turn the drawer runner over to view from the back.

• Detach the drawer slide from the main sliding runner by pulling the clip as

indicated by the arrow on the clip. Line up the three holes in the metal runner with

the pre-drilled holes in the End Panel. Attach these runners using the Euro screws.

Do this for both End Panels DO NOT re-insert the drawer slide at this stage. Refer

to images 1 & 2 page 9

Door Hinge Clips –

Attach the Hinge Clips before assembling the cabinetry.

With the arrow indicator on the hinge block facing to the front edge of the panel.

• Line up the Hinge Plate with the pre-drilled holes in the End Panel. Fix these by tapping

them in gently with a hammer, then tightening the screws. Refer to image 6 page 10

Drawer Clips –

Insert these into the drawer front ensuring the up & down arrows on the drawer clips are facing

the outside edge of the drawer panel. Fix these into the drawer front by tapping them in gently

with a hammer. Refer to image 10 page 10

End

NOTE: In the Top

Panel Insert the cam

pins on the same

side as the Cam

Lock

Top

NOTE: In the

Bottom Panel Insert

the cam pins on the

opposite side to the

Cam Lock.

Drw Bot

Bottom