Table of Contents
Advertisement
2.1.2
Mounting the Device on a DIN Rail
For DIN rail installations, the RUGGEDCOM RS1600 can be equipped with panel/DIN
rail adapters pre-installed on each side of the chassis. The adapters allow the device
to be slid onto a standard 35 mm (1.4 in) DIN rail.
To mount the device to a DIN rail, do the following:
1.
2.
2.1.3
Mounting the Device to a Panel
For panel installations, the RUGGEDCOM RS1600 can be equipped with panel/DIN rail
adapters pre-installed on each side of the chassis. The adapters allow the device to
be attached to a panel using screws.
RUGGEDCOM RS1600
Installation Manual, 01/2021, C79000-G8976-1013-03
Align the adapters with the DIN rails and slide the device into place.
3
Panel/DIN Rail Adaptor
1
DIN Rail
2
Screw
3
Figure 2.2
DIN Rail Mounting
Install one of the supplied screws on either side of the device to secure the
adapters to the DIN rails.
2.1.2 Mounting the Device on a DIN Rail
Installing Device
1
2
3
9
Advertisement
Table of Contents
