Table of Contents
Advertisement
BASIC OPERATION
Step 1: Filling water tank
•
Ensuring the device is turned off (Steam adjustment dial set to 'Off'), remove the
water tank cap (Figure 1a).
•
Using the supplied water cup (you may also use the funnel, not pictured), fill the
water tank with water. The water tank's maximum capacity is 380ml, do not
exceed this amount. Hold the device level when filling.
•
Replace the cap, ensuring it is pushed down firmly to create a tight seal.
1a. Remove tap
Notes:
•
In order to significantly reduce mineral build-up and prolong the life of the device,
use of distilled or de-mineralized water in the unit is highly recommended.
•
The tube which transfers water from the water tank to the boiler is weighted down
with a brass ball. This is an intentional design to improve efficiency of water usage.
It is normal for this ball to create a rattling sound inside of water tank during use.
•
If you think brass ball has come loose from tube, refer to the Troubleshooting
section of this user guide.
1b. Fill tank
1c. Replace cap
Advertisement
Table of Contents
