Table of Contents
Advertisement
OPERATION
Starting the Steam Mop
•
Make sure the device has been filled with water before turning on. Do not run dry.
•
Plug the power cord into a power outlet and switch on.
•
The indicator light will turn red on each side of the water tank and the steam mop
will begin preheating. If the indicators do not illuminate, refer to the
"troubleshooting" section for more details.
It will take approximately 25 seconds for preheating. Once the steam mop is ready
to use the water tank will glow blue.
Note: If power is interrupted during the preheating phase, when the steam mop is
turned on again it will repeat the preheating phase.
•
A full water tank will run for approximately 20 minutes. When the water level runs
low, the indicator will glow red and begin flashing.
•
Press and hold the steam button to release steam.
•
Direct the outlet (with any connected nozzle or accessories) toward the surface you
wish to steam while holding the steam button. To stop flow of steam, release the
button.
•
Increase the level of steam by turning steam control knob clockwise
•
Turn the steam control knob counter-clockwise to reduce the amount of steam.
Note:
Before storing the steam mop, remove the water tank before turning off the
power and then let the product run for a while, until there is no steam.
12
Advertisement
Table of Contents
