8.1 Initial Setup for Servo Amplifiers
If you use parameters "Absolute encoder setup", "Output pulse counts per one motor rev...",
"RTEX communication cycle setup", and "RTEX command updating cycle setup", change
the settings according to the operating environment.
4.
Click [OK].
The "Setting Complete" dialog box will be displayed.
5.
Click [OK].
The main pane will be displayed. Start the servo amplifier.
8.1.4 Disconnecting the Servo Amplifier from the PC
Disconnect the USB cable connecting the PC and the servo amplifier.
8-4
WUME-GM1RTXSU-01