11.1 Setting up the Servo Amplifier Connected to the GM1 Controller
11.1 Setting up the Servo Amplifier Connected to the GM1 Controller
The PC communicates with the servo amplifier connected to the GM1 Controller.
Connect the PC and GM1 Controller with a USB cable or Ethernet cable. With the GM1
Controller and servo amplifier connected with a Cat5e shielded cable, set up the servo
amplifier.
Make this setting only after the connection between the GM1 Controller and the servo
amplifier has been established.
11.1.1 When Connected Using the Ethernet Cable
If connected using the Ethernet cable, use the following procedure.
1.
Start PANATERM Lite for GM.
The "Connect" dialog box will be displayed.
2.
Select "Connect to the GM series controller with LAN" and click the [OK] button.
The "Communication timeout settings" dialog box will be displayed
11-2
WUME-GM1RTXSU-01