Operation - F.F. Group CRH/2-20-BL 20V PLUS Original Instructions Manual

10 | English
when pushing the battery unlocking button unin-
tentionally. As long as the battery is inserted in
the power tool, it is held in position by means of
a spring.
To remove the battery:
Push the battery against the base of the power
ƒ
tool and at the same time press the battery un-
locking button.
Pull the battery out of the power tool.
ƒ
BATTERY CHARGE-CONTROL INDICATION
The three green LEDs of the battery charge-control
indicator indicate the charge condition of the bat-
tery. For safety reasons, it is only possible to check
the status of the charge condition when the ma-
chine is at a standstill.
Push button to indicate the charge condition (also
ƒ
possible when the battery is removed). The bat-
tery charge-control indicator automatically goes
out after approx. 5 seconds.
LED battery status indicator
Green LED on
Yellow LED on
Red LED on
AUXILIARY HANDLE (FIGURE F, G)
You will be able to obtain a safe position when
working by rotating the handle attachment. Loos-
en and turn the handle attachment in an anticlock-
wise direction.
DEPTH STOP (FIGURE H, I)
Loosen the winged screw on the auxiliary han-
dle. Adjust the drilling depth on the depth stop.
Retighten the winged screw.
SELECTING DRILL CHUCKS AND TOOLS
For hammer drilling, SDS-plus tools are required
that are inserted in the SDS-plus drill chuck.
For drilling without impact in wood, metal, ceramic
and plastic as well as for screwdriving, tools with-
out SDS-plus are used (e.g., drill bits with cylindri-
cal shank). For these tools, a keyless chuck or a key
type drill chuck are required.
CHANGING THE TOOL
The dust protection cap (8) largely prevents the
entry of drilling dust into the tool holder during
operation. When inserting the tool, take care that
the dust protection cap (8) is not damaged.
A damaged dust protection cap should be changed
f
immediately. We recommend having this carried out
by an authorized service.
INSERTING SDS-PLUS DRILLING TOOLS
The SDS-plus drill chuck allows for simple and con-
venient changing of drilling tools without the use
of additional tools.
Clean and lightly grease the shank end of the tool.
ƒ
Insert the tool in a twisting manner into the tool
ƒ
holder until it latches itself.
Check the latching by pulling the tool.
ƒ

OPERATION

INSERTING THE BATTERY
Use only original FF GROUP lithium-ion batter-
f
ies with the voltage listed on the nameplate of
your power tool. Using other batteries can lead to
injuries and pose a fire hazard.
Set the rotational direction switch (3) to the cen-
ƒ
tre position to protect the power tool against ac-
cidental starting.
Insert the charged battery from the front into the
ƒ
base of the power tool. Push the battery com-
pletely into the base.
SETTING THE OPERATING MODE
Capacity
Please trigger the release button of the operational
>100%
mode selection switch slightly.
>67%
>30%
1. Drill mode:
Turn the mode
selector switch 5
to direction.
2. Hammer drill
mode:
Turn the mode
selector switch 5
to
3. Chisel mode
Turn the mode
selector switch 5
to
CRH/2-20-BL 20V PLUS
Warning!
Change the operating mode only when
the machine is switched off! Otherwise,
the machine can be damaged
direction.
direction.