Ford F100 1959 Shop Manual page 39

PART 1-2 - 223 SIX ENGINE
1 -35
FIG. 35- R ear
Oil Sea l To Block In sta lla tion
FIG.
37 - Thru sl Bearing Alig nment
ward pr~ssure o n the crankshaft and
tighten Ihe cap bolts 10 95·105 foot-
pounds torque (Fig. 37).
5. Force the crankshaft toward
the rcar of the engine. Install a dial
indicator so the contact point rests
against the crankshaft flange and the
indicator axis is para llel 10 the crank·
shaft axis (Fig. 38). SCI the dial on
zero, the n push the cra nkshaft for-
ward and note the rcading on the
dial.
If the end play exceeds the wear
imit, replace the thrust bearing. If
.he e nd play is less than the minimum
li mit, inspect the thrust bearing faces
for scratches, burrs, nicks. or dirL If
the thrust faces are nol defective or
FIG. 36-Rear
Oil Seol To Rear Bearing
Cap Installation
I'ItY BACII:WARO
dirty, they probably were not aligned
properl y. Install thc thrust bearing
and align the faces following the rec-
ommended procedure, then recheck
thc end play.
6. Check the clearance of each
connecting rod bearing following the
procedure under "Connecting Rod
Bearing Replacement" in Section 8.
If the bearing clearances are satisfac-
tory, apply a light coat of engine oil
10
the journals and bearings, then in-
slall thc connecting rod caps. Tighten
thc nuts
10
45-50 foot-pounds to rque.
Check thc side clearance between Ihe
connecting rods on each crankpin
following the procedurc under " Piston
and Connecting Rod InSlallation."
1805_A
7. Install the fl yw heel, oil pump,
oil pump screen and inlet tube as-
sembly, crankshaft damper key, and
thc oit pan.
8. Install the sprockets and timing
chain with the timing marks aligned
(Fig. 25). Install the crankshaft front
oil slinger, cylinde r front cover, and
the crankshaft damper. Install the
water pump, distributor, crankcase
ventilat ion tube, oil level dip stick,
pulley, and fan. Install the generator,
then install and adjust the drive belt.
9. Install the engine in the chassis.
Fill and bleed the cooling system. Fill
the crankcase with the proper grade
and quantity of engine o il . Start the
engine and check and adjust the igni-
tion timing. Operate the engine at fas t