Table of Contents
Advertisement
SMBus Connector
The SMBus (System Management Bus) connector is used to connect SMBus devices. It is a
multiple device bus that allows multiple chips to connect to the same bus and enable each
one to act as a master by initiating data transfer.
Chapter 2 Hardware Installation
Chapter 2
SMBus
1
5
2
28
Standby Power LED
This LED will lit red when the system is in the standby mode. It indicates that there is power
on the system board. Power-off the PC and then unplug the power cord prior to installing any
devices. Failure to do so will cause severe damage to the motherboard and components.
Standby Power LED
www.dfi .com
Advertisement
Table of Contents
