DFI KD331-C236/Q170 User Manual page 44

COMA to COMF and Pci Serial Port 0:22:3
InsydeH2O Setup Utility
Advanced
PortEnable <Enabled>
UseGlobalSetting <Enabled>
F1 Help ↑/↓ Select Item F5/F6
Esc Exit ←/→ Select Item Enter

PortEnable
This field is used to enable or disable the COM port to redirect the console.
UseGlobalSetting
This field is to enable or disable to use global setting. When enabled the global set-
ting, setting of the COM port will be the same as those in Console Redirection section.
When disabled the global setting, setting of the COM port can be configured indepen-
dently in this section.
Chapter 3 BIOS Setup
Chapter 3
Rev. 5.0
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

When UseGlobalSetting is set to disabled, the screen will appear like shown below:
Advanced
PortEnable
UseGlobalSetting
Terminal Type
Baud Rate
Data Bits
Parity
Stop Bits
Flow Control
F1 Help ↑/↓ Select Item
Esc Exit ←/→ Select Item

44
InsydeH2O Setup Utility Rev. 5.0
<Enabled>
<Disabled>
<VT_100>
<115200>
<8 Bits>
<None>
<1 Bit>
<None>
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

www.dfi .com