Table of Contents
Advertisement
SBI-7428R-C3 Blade Module User's Manual
Table 6-5. Chipset Configuration Sub-menu (Continued)
Menu Option
Device Tagging
South Bridge Configuration
USB Information
Legacy USB Support
XHCI Hand-off
EHCI Hand-off
Port 60/64 Emulation
USB 3.0 Support
EHCI1
EHCI2
Menu Option
SATA Controller
Configure SATA as
Support Aggressive
Link Power Mana
SATA Port 0~5
Settings
Spin Up Device
SATA Device
Type
Description
This setting Enables or Disables Device Tagging in your system.
This sub-menu allows you to configure South Bridge parameters.
Static information for USB Module Version and USB devices
connected is shown at the top of this screen.
This setting allows you to enable the use of Legacy USB devices. If
this option is set to Auto, legacy USB support will be automatically
enabled if a legacy USB device is installed on the serverboard, and
disabled if no USB devices are connected. The Disable option will
keep USB devices available only for EFI applications. The options
include Disabled, Enabled and Auto.
This is a workaround for OSes without XHCI hand-off support. The
XHCI ownership change should be claimed by the XHCI driver.
Options include Enabled and Disabled.
This setting is a workaround for OSes without EHCI hand-off support.
The EHCI ownership change should be claimed by the EHCI driver.
Options include Enabled or Disabled.
This setting Enables or Disables I/O port 60h/64h emulation support.
This should be enabled for the complete USB keyboard legacy
support for non-USB aware OSes.
This setting enables or disables USB 3.0 Support. Options include
Smart Auto, Auto, Enabled or Disabled.
This setting controls the USB EHCI (USB 2.0) functions for EHCI1.
One of these EHCI controllers must always be enabled. Options
include Enabled or Disabled.
This setting controls the USB EHCI (USB 2.0) functions for EHCI2.
One of these EHCI controllers must always be enabled. Options
include Enabled or Disabled.
Table 6-6. SATA Configuration Sub-menu
Description
This setting allows you to Enable or Disable the SATA device.
Use this setting to select the SATA mode you desire. Options include IDE, AHCI
and RAID.
Use this setting to Enable or Disable SALP.
For each of the ports you many configure the settings listed below.
This setting allows you to Enable or Disable the Spin up Device for the system. If
enabled for any ports staggered spin up will be performed and only the drives
that have this option enabled will spin up at boot. Otherwise all drives spin up at
boot if this setting is disabled.
This setting allows you to identify that the SATA port is connected to either a
Solid State Drive or a Hard Disk Drive.
6-12
Advertisement
Table of Contents
