Table of Contents
Advertisement
Table 6-5. Chipset Configuration Sub-menu (Continued)
Menu Option
Link Frequency Select
Link L0p Enable
Link L1 Enable
COD Enable
Early Snoop
Isoc Mode
Memory Configuration
Enforce POR
Memory Frequency
Data Scrambling
DRAM RAPL Baseline
Set Throttling Mode
Socket Interleave Below
4GB
A7 Mode
DIMM Information
Memory RAS
Configuration
RAS Mode
Memory Rank Sparing
Patrol Scrub
Patrol Scrub Interval
Demand Scrub
Description
This setting allows you to select the QPI Link Frequency. Options
include 6.4GB/s, 8.0GB/s, 9.6GB/s, Auto and Auto Limited.
This setting Enables or Disables Link L0p.
This setting Enables or Disables Link L1.
This setting Enables or Disables Cluster on Die for the system.
This setting enables or disables Early Snoop for the system. Options
include Disable, Enable or Auto.
This setting allows you to Enable or Disable Isoc in your system.
This sub-menu displays Memory Configuration settings.
This setting allows you to enforce POR restrictions for DDR4
frequency and voltage programming. Options include Enabled or
Disabled.
This sets the maximum memory frequency in Mhz. Options include
Auto and frequencies between 1333 ~ 3200.
WARNING! DO NOT SELECT RESERVED.
Use this setting to enable data scrambling for your system. Options
include Auto, Disabled and Enabled.
This setting enables and specifies the DRAM RAPL Baseline mode.
Options include Disable, DRAM RAPL Mode 0 and DRAM RAPL
Mode 1.
This setting sets the Thermal Throttling mode for your system to
either Disabled or CLTT.
This setting splits teh 0-4GB address space between two sockets, so
that both sockets get a chunk of the local memory below 4GB.
Options include Disable or Enable.
This setting Enables or Disables A7 mode in your system.
Static DIMM presence and size information is shown when this
sub-menu is selected.
This sub-menu displays and provides settings to change Memory
RAS.
This setting Enables or Disables RAS Mode. Enabled Sparing and
Mirroring is not supported. If enabled, Sparing will be selected.
This setting Enables or Disables Memory Rank Sparing in your
system.
This setting Enables or Disables Patrol Scrub in your system.
This setting selects the number of hours (1-24) required to complete
full scrub. A value of 0 means auto. Default is 24. Settings are
increased or decreased using the "+" or "-" keys on your keyboard's
number pad.
This setting Enables or Disables Demand Scrub in your system.
6-11
Chapter 6: BIOS
Advertisement
Table of Contents
