Table of Contents
Advertisement
SBI-7428R-C3 Blade Module User's Manual
Jumpers
The jumpers present on the serverboard are used by the manufacturer only; there are
no jumpers used to configure the operation of the serverboard.
CMOS Clear
JBT1 is used to clear CMOS and will also clear any passwords. JBT1 consists of two
contact pads located near the BIOS chip.
Clearing CMOS
1. First power down the blade and remove it from the enclosure.
2. Remove the blade cover to access the serverboard (see
Blade Cover" on page 3-2
object such as a small screwdriver.
3. Replace the cover, install the blade back into the enclosure and power it on.
for further details). Short the CMOS pads with a metal
4-6
"Removing/Replacing the
Advertisement
Table of Contents
