Table of Contents
Advertisement
Overview
The MUNGO560 single board computer is equipped with an AMI BIOS, which is stored in Flash
ROM. This AMI BIOS features a built-in setup program, allowing users to modify the system
configuration. The system configuration is stored in CMOS RAM, and so it is retained during
power-off periods. When the computer is turned on, the MUNGO560 communicates with
peripheral devices and checks its hardware resources against the information stored in CMOS
memory. If an error is detected or CMOS parameters need to be initially defined, the diagnostic
program will prompt the user to enter the SETUP program. Some errors abort the start-up.
The Setup program is for viewing and changing the BIOS settings for a computer. Setup is
accessed by pressing the [Del] key after the POST memory test begins and before the operating
system boot begins.
Main Menu
To start the AMI BIOS Setup utility, turn on or reboot your system. AMI BIOS displays this
message:
Press <DEL> to enter SETUP
Pressing [DEL] displays the Main Menu, which looks like this:
Overview
5-3
MUNGO560 User's Guide
Advertisement
Chapters
Table of Contents
