Inspur NF5888M5 User Manual page 48

Menu Instruction Table
Create RAID Volume
Delete RAID Volume
Reset Disks to Non-RAID
Mask Disk as Spare
Exit
3.2 Create RAID Volume menu. After entering SATA RAID configuration interface, you could
use up and down arrow keys to select this menu, and then press Enter to enter the Create
RAID Volume menu, or directly input the number before the menu to enter the Create RAID
Volume menu. For other menu operations that are similar, it will not be repeated here.
A Create RAID Volume instance is shown in the following figure:
Create RAID Menu Instruction Table
Interface Parameters
Name
RAID Level
Select Disks
Strip Size
Capacity
42
To create an RAID volume
To delete an existed RAID volume
To reset disks in RAID volume, and to restore them to non-RAID
status
To mask the disks as spare disks. The data will be cleared, and these
disks can not be selected during RAID setting. It can be restored
through the Reset Disks to Non-RAID menu.
To exit SATA Host RAID configuration interface
Fig. 2.16
Function Description
Please enter a volume label name less than 16 characters without containing
any special characters.
Please select RAID volume level. If no volume has been created at present,
there are four volume levels of RAID0 (Stripe), RAID1 (Mirror), RAID10 (RAID0+1)
and RAID5 (Parity) for selection. Please select volume level according to actual
requirements.
RAID0: This RAID volume is allowed to be made on 2 or above disks.
RAID1: This RAID volume is allowed to be made on 2 disks.
RAID10: This RAID volume is allowed to be made on 4 disks, which is only
available when disk quantity is 4 or above.
RAID5 (Parity): This RAID volume is allowed to be made on 3 or above disks.
Select disks to make RAID volume, press Enter, select X, and then press Enter to
return to Create RAID Volume interface.
Please select the strip size, only RAID0 and RAID5 volumes could enable this option.
Set the volume capacity.