Inspur NF5888M5 User Manual page 45

Create RAID Menu Instruction Table
Interface Parameters
Name
RAID Level
Select Disks
Strip Size
Capacity
Create Volume
2.3 Delete RAID volume. Select a created RAID Volume, press Enter. Select "Delete", there
will be a prompt. To delete the volume, select "Yes" and press Enter; to cancel the deletion,
select "No" and press Enter.
Fig. 2.10
Function Description
Please enter a volume name less than 16 characters without containing any
special characters.
Please select the RAID volume level. If no volume has been created at present,
there are four volume levels of RAID0 (Stripe), RAID1 (Mirror), RAID10 (RAID0+1)
and RAID5 (Parity) for selection. Please select the volume level according to actual
requirements.
RAID0: This RAID volume is allowed to be made on 2 or above disks.
RAID1: This RAID volume is allowed to be made on 2 disks.
RAID10: This RAID volume is allowed to be made on 4 disks, which is only available
when disk quantity is 4 or above.
RAID5 (Parity): This RAID volume is allowed to be made on 3 or above disks.
Select disks to make RAID volume, press Enter, select X, and then press Enter to
return to Create RAID Volume interface.
Please select the strip size, only RAID0 and RAID5 volumes could enable this
option.
Set the volume capacity, and the maximum capacity is shown in the Help
information on the right side.
After finishing the above settings, select this option to create RAID volume.
BIOS setup
39