Eaton PXR10 Manual page 64

9 Modbus RTU – integrated Modbus port specification
9.3 Modbus register map
Register Bit Mask field
number field
403006 8 0x0100
BBE 0x0001
403007 2 - 0 0x0007
1)
403009 0 0x0001
1)
403010 0 0x0001
1)
403011
1)
403012
403015
403016
1)
403018
1)
403021 0xBCC
1) PXR25 only!!
60
Setpoint name
Maintenance mode: state
Maintenance mode:
remote control
Maintenance mode: Trip
setting
Direction of incoming
supply
Sign convention
Power demand window
Power demand interval
Configuration of relay 1
Configuration of relay 2
Phase sequence – phase
L1 (A)
Alarm - Residual Life
In setting group 0, the maintenance mode setting (register 403006) can be
divided into two parts. The high byte is read only, and is used for the status
indication of the maintenance mode, the comprehensive results of the
maintenance mode rotary switch, the secondary terminal, and the
communication settings. The low byte can be configured and is used to
indicate the maintenance mode settings via the communication port
(e.g. Modbus, CAM or USB).
The respective protection settings may vary according to the size, type and
rated operational current of the release.
PXR Electronic trip unit 01/21 MN012005EN www.eaton.com
R/W Format Description or value
R Encoded 0: off
1: on
R/W Encoded 0: off
1: on
R/W Encoded 1: 2.5 x I
2: 4 x I
3: 6 x I
4: 8 x I
5: 10 x I
R/W Encoded 0: forward
1: reverse
Note:
only available on the PXR25
R/W Encoded Sign convention:
0: IEC
1: IEEE
2: IEEE old
R/W Encoded Power demand:
0: fixed
1: sliding
R/W Encoded Power demand:
5 - 60 min (1 min increments)
R/W Encoded
Configuration of relay 1 and relay 2:
￫ table 21, page 44
R/W Encoded
R/W Encoded Phase L1 (A)
0: counterclockwise
1: clockwise
R/W Encoded Range: 50 - 100, step size 1,
default value: 75
Alarm level value 100 ≙ 0 % residual life
Alarm level value 75 ≙ 25 % residual life
Formula for conversion:
Alarm level expressed as a percentage
= 100 - point value
n
n
n
n
n
Unit
–
–
A