Section 3: Preparation For Use - JETStream PI-123 Product Instructions

Section 3: Preparation for Use

15K Tube Spinner with FP Nozzle
22K Tube Spinner with HPF Nozzle
Nozzle Sleeve Body
Nozzle Sleeve Body
3.0 BEFORE PUTTING TUBE SPINNING NOZZLE INTO SERVICE
NEW TUBE SPINNING NOZZLE
3.1 Check the Tube Spinning Nozzle carefully upon removal from its ship-
ping container for damage.
PREVIOUSLY USED TUBE SPINNING NOZZLE
3.2 Inspect all components.
3.3 The Tube Spinning Nozzle body, sleeve, and front nozzle should be
inspected and cleaned to ensure no debris has entered the orifice that
could plug the nozzle and over-pressurize the system.
3.4 Remove the Tube Spinning Nozzle from service if the body, sleeve,
thruster, or front nozzle show signs of cracking or excessive abrasion.
3.5 Review Flow Charts in Appendix B to decide on nozzle configuration
and proper flows for application.
May 2017 PI-123 15