Before Use - Panasonic MX-M300 Operating Instructions Manual

Before Use

The illustrations inside mainly shows MX-M300 model.
Wash each part except the Mill Container Base before using the appliance for the fi rst time (page EN9).
Note:
• Place your thumb on the Rib when assembling or disassembling the Blender Jug to its
Base for easier turning.
Blender
(For MX-M300 only)
Turn the Blender Jug Base
clockwise to disassemble.
• Be careful with the Blender
Cutting Blade.
Pull up the Blender Jug to
release from the Blender Jug
Base.
Blender
(For MX-M300 only)
Place the Blender Gasket to
the Blender Jug Base.
• If the Blender Gasket is not
placed, it will cause leakage.
Follow the assembly
sequence in the direction
of arrow as illustrated.
Attach the Blender Jug to
the Blender Jug Base and
tighten the Blender Jug Base
anticlockwise to assemble.
• Ensure that the Blender Gasket
is set properly and the Blender
Jug is tightened securely.
Otherwise, it may cause leakage.
• Do not attach or remove the
Blender Jug after the Blender
Jug Base is placed on the Motor
Housing. The liquid will leak or
the motor will not operate.
Note:
• Do not touch any of the Safety Lever on the Blender Jug Base during assembly.
• Do not assemble the Blender Jug under reverse condition.
Blender_MX-M300_210_200_100_EVT.indb 5 Blender_MX-M300_210_200_100_EVT.indb 5
To Disassemble
Dry Mill
(Except for MX-M100)
1000
Turn the Mill Container
800
600
upside down and turn the Mill
400
Container Base anticlockwise
to disassemble.
• Be careful with the Mill Cutting
Blade.
Pull up the Mill Container
Base to release it from the Mill
Container.
To Assemble
Dry Mill
1000
800
(Except for MX-M100)
600
Turn the Mill Container upside
400
down.
Attach the Mill Container
Base to the Mill Container and
turn the Mill Container Base
clockwise until a "click" sound
is heard.
1000
800
600
400
4 0 0
6 0 0
8 0 0
1 0 0 0
Rib
EN5
6/11/2019 11:58:49 AM 6/11/2019 11:58:49 AM