Before Use - Panasonic KM5070 Operating Instructions Manual

Before Use

Wash each part except the Mill Container Base before using the appliance for the fi rst time.
Note:
• Place your thumb on the Rib when assembling or disassembling the Blender Jug to its
Base for easier turning.
Blender
Turn the Blender Jug Base
clockwise to disassemble.
• Be careful with the Blender
Cutting Blade.
Pull up the Blender Jug to
release from the Blender Jug
Base.
Blender
Place the Blender Gasket to
the Blender Jug Base.
• If the Blender Gasket is not
placed, it will cause leakage.
Follow the assembly
sequence in the direction
of arrow as illustrated.
Attach the Blender Jug to
the Blender Jug Base and
tighten the Blender Jug Base
anticlockwise to assemble.
• Ensure that the Blender Gasket
is set properly and the Blender
Jug is tightened securely.
Otherwise, it may cause leakage.
• Do not attach or remove the
Blender Jug after the Blender
Jug Base is placed on the Motor
Housing. The liquid will leak or
the motor will not operate.
To Disassemble
Dry Mill
Turn the Mill Container
1500 upside down and turn the Mill
1000
Container Base anticlockwise
500
to disassemble.
• Be careful with the Mill Cutting
Blade.
Pull up the Mill Container
Base to release it from the Mill
Container.
To Assemble
Dry Mill
1500
Place the Mill Gasket to the
1000
Mill Container Base.
500
• If the Mill Gasket is not placed,
it will cause leakage.
Turn the Mill Container upside
down.
Attach the Mill Container
Base to the Mill Container and
turn the Mill Container Base
clockwise until a "click" sound
is heard.
• Make sure that the Mill Gasket
is fi tted properly on the Mill
Container Base. Otherwise, it
may cause leakage.
Rib
EN5