After Use - Panasonic MX-M300 Operating Instructions Manual

After Use

It is easier to remove dirt if the Blender is prewashed before cleaning the Blender. (Operate for about 30 seconds after
fi ll in normal water about half of the Blender Jug Working Capacity.)
• During prewash, do not fi ll in the normal water more than the amount indicated. It may cause high vibration.
Note:
• Unplug the appliance before cleaning. Handle the Cutting Blades and glass part (For MX-M300 only) carefully during
cleaning.
• Do not use benzene, thinner, alcohol, bleach, polishing powder or metal brush to clean the appliance. The surface
may be damaged.
• Do not place the appliance in the dishwasher or the dish dryer for cleaning.
• Some discolouration of the plastic parts may occur upon usage but it does not affect usage.
• Make sure to clean the appliance after every use.
• Avoid using hand to clean the Cutting Blades.
• Do not use water or hand to clean the Mill Cutting Blade.
Scraper / Blender Jug Unit
Mill Container
(Except for MX-M100)
Wash with diluted dish soap
(neutral) and a soft sponge. After
washing, be sure to rinse and wipe
dry thoroughly.
Blender Gasket (For MX-M300 only)
Before cleaning, make sure to take
out the Blender Gasket.
Blender Cutting Blade
(For MX-M300 only)
Clean the Blender Cutting Blade
with a brush under running water.
Do not use hand to clean the
Blender Cutting Blade.
* Brush is not provided.
Note:
• Do not wrap the Cord around the Motor Housing.
• Mount the Blender Jug onto the Blender Jug Base and store it.
• Mount the Mill Container onto the Mill Container Base and store it.
Blender_MX-M300_210_200_100_EVT.indb 9 Blender_MX-M300_210_200_100_EVT.indb 9
Cleaning
1000
800
600
400
Motor Housing
Wipe the Motor
Housing with a
damp cloth.
Storing
Blender Cutting Blade
(Except for MX-M300)
Wash the Cutting Blade under running
water and clean by using a brush.
Do not use hand to clean the Cutting
Blade.
* Brush is not provided.
Mill Container Base / Mill Cutting Blade
(Except for MX-M100)
Clean the Mill Container Base and the
Mill Cutting Blade with a brush. Do
not use water or hand to clean the Mill
Cutting Blade.
* Brush is not provided.
EN9
6/11/2019 11:58:51 AM 6/11/2019 11:58:51 AM