Table of Contents
Advertisement
Maintenance
Servicing
No maintenance should be performed while the equipment is in use.
If a power module or any part of the electrical system has been damaged or compromised in anyway, remove
from use immediately and do not use.
Warning: The ZeroWire Mobile charging station and power modules have no user serviceable parts. Do
not disassemble or modify the charging station and power modules in any way.
Warning: Use of non-NDS power modules will render the unit inoperable. Use of non-NDS power
modules may present a risk of fire or explosion.
General Precautions
• Before use, confirm that both power modules are fully charged and correctly docked.
• Do not use or store any part of the ZeroWire Mobile system, including power modules and charger in a
location exposed to direct sunlight or sources of direct heat such as fire or a heater.
• Power modules can only be charged using approved NDS ZeroWire Mobile Chargers.
• Do not submerge power modules in water or any fluid.
• Do not strike, throw, drop, or subject power modules to physical shock.
• Do not pierce casing of power modules with nails or other sharp objects.
• Do not attempt to open the power module enclosure.
• Do not stand on a power module.
Note: It is recommended that power modules be regularly inspected for enclosure damage. If a unit is damaged,
it should be immediately removed from use.
Cleaning
The ZeroWire Mobile system should be kept clean and free of dust. The Dock, charger and Power Module should
be cleaned using a damp cloth with water or alcohol solution. Please observe the follow precautions.
Power modules are protected by an impermeable watertight enclosure, allowing the units to be safely cleaned
by using a dampened cloth.
Please observe the follow precautions:
• Turn the system off and disconnect from the AC power supply before cleaning
• Do not pour fluid over any part of the system.
• Do not allow fluids to penetrate the exterior surface of the dock module(s)
• Do not use abrasive cleaners or strong solvents such as acetone or acetone-based compounds.
Warning: Prior to cleaning, units should be turned OFF and disconnected from power sources.
• Do not use abrasive cleaners or strong solvents such as acetone or acetone-based compounds.
Warning: Do not pour fluids over any part of the ZeroWire Mobile Stand.
• Do not allow fluids to penetrate the exterior surface of the dock modules, as severe damage to the unit
can result.
In the event of fluid penetration, use a dry cloth to remove fluid from all external surfaces, and allow the unit to
dry thoroughly. Consult a qualified technician before attempting further use.
12 | Maintenance
Advertisement
Table of Contents
