Table of Contents
Advertisement
External Charger
The ZeroWire Mobile external charger (P/N: 30H0006) connects directly to the stand. The external charger can be
used with or without Power Modules installed. This allows for flexibility of power sources.
Note: The external charger can be used as an alternative to the 4-Bay Charger but may present a tripping hazard
if connected during use.
When the external charger is connected with Power Modules installed:
• The display will be powered by the external charger, not the Power Modules.
• The mounted power modules will charge at a slow rate.
When the external charger is connected without Power Modules installed:
• The display will be powered by the external charger.
• Power Modules can be installed and removed while the external charger is connected, without affecting
power to the display.
The external charger port covered is the NDS badge as indicated in the figure below.
Using nonmetallic flat head screwdriver, carefully pry off the port cover to access the port and avoid scratching
the plastic surface. Using the adhesive on the back of the label, the NDS Label can be temporarily placed on the
base of the stand. Do not apply too much pressure to make it difficult to remove later.
The external charger port.
The external charger port with external charger connected.
22 | External Charger
Advertisement
Table of Contents
