Table of Contents
Advertisement
5.0
RECOMMENDED TOOLS AND TEST EQUIPMENT
DTMF Test Set
Volt/Ohm Meter
3/8" Nut Driver
5/16" Nut Driver
Flat Blade Screw Driver
Security Tool 301-064
6.0
INSTALLATION NOTES AND ASSEMBLY INSTRUCTIONS
6.1
Using a 301-064 security tool (sold separately) remove the four security
screws.
6.2
The security tool is for a standard 5/32" button screw generally used on
the framework of the phone booths.
6.3
Separate the cover assembly from the Weatherproof housing or enclosure.
6.4
Run the inside station wire through the housing or enclosure and terminate
the wire on the RJ11C terminal block.
6.5
The use of a gas tube or carbon station protectors is recommended. The
station ground should not exceed 50 ohms.
6.6
Plug the modular line cord from the PC board into the RJ11C terminal
block.
6.7
Dress the line cord away from the security screws and seat the phone into
the housing or enclosure.
6.8
Secure the telephone assembly by replacing and tightening the four
security screws.
A.
B.
C.
D.
*****WARNING*****
Never install telephone wiring during a lightning storm.
Never install telephone jacks in wet locations unless the jack is
specifically designed for wet locations.
Never touch uninsulated telephone wires or terminals unless
the telephone line has been disconnected at the network
interface.
Use caution when installing or modifying telephone lines.
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
Issue 4.0
8
Advertisement
Table of Contents
